Skip to content

Locations and reports

Radon Levels in Pike County, Mississippi

EPA puts Pike County in Zone 3, its lowest radon zone. Homes with elevated levels occur in all three zones, so only a test measures yours.

Data checked By Radon411Methodology

  • Highest bordering

    0.0%

    Tangipahoa Parish

    Tangipahoa Parish
    0.0%

    1 of 5 neighbours have 30+ tests, 2006 to 2015

  • Nearest county

    0.0%

    Tangipahoa Parish, 38 miles

    Tangipahoa Parish
    0.0%

    Share at 4+ pCi/L, 43 tests, 2006 to 2015

  • Ground above low

    None

    8.1 pts below MS

    Pike
    0.0%
    MS
    8.1%

    Share of land USGS rates moderate or high potential

  • Tests reported

    0

    None published

    A home here needs its own test

  • EPA radon zone

    Zone 3

    Lower potential

    1. 1
    2. 2
    3. Zone 3

    1 highest, 3 lowest

    EPA predicts under 2 pCi/L indoors

Read a result for Pike County

Starts at EPA's action level

4.0pCi/L

EPA’s own thresholds; the figures are the area’s, never this home’s.

EPA’s reading of 4.0 pCi/L

At or above 4 pCi/L

  1. Under 20 to 1.9 pCi/L
  2. 2 to 4consider a fix
  3. 4 and aboveEPA says fix it

This result is at or above 4 pCi/L. EPA recommends fixing a home when the radon level is 4 pCi/L or higher.

The data

Pike County, At a glance

Pike County at a glance

Predicted: EPA radon zone

EPA Zone 3: lower predicted potential

is EPA's lowest class, and its forecast for Pike County as a whole is an average indoor of less than 2 pCi/L (less than 75 Bq/m³). A low zone clears no address in it: homes above EPA's turn up in all three zones.

USGS geologic potential: Low across 100% of the county's area

Predicted: EPA Map of Radon Zones

Measured: tests reported to CDC

No CDC test figures here

CDC has published no radon test figures for Pike County. Tangipahoa Parish, LA, the one bordering county with a figure over the 2006 to 2015 laboratory totals, reported 0.0% of its tests at or above 4 pCi/L.

How to read these figures

Pike County, Compared

Pike County radon figures, compared

Calculated by Radon411

Pike County is in a state CDC's county radon counts do not reach: no Mississippi county has a figure, while 2,669 counties elsewhere do over the 2006 to 2015 laboratory totals. Across every county in the country with a figure (2,669), 36.3% of reported tests reached that level; no Mississippi county contributes to that pool.

Tangipahoa Parish, LA, the one bordering county with a figure over the 2006 to 2015 laboratory totals, reported 0.0% of its tests at or above 4 pCi/L. Farther out, East Baton Rouge Parish, LA (60 miles away) at 0.0%, Jefferson Parish, LA (97 miles away) at 1.5% and Mobile County, AL (133 miles away) at 4.4% have figures too.

EPA's 1993 map puts Pike County in Zone 3, its lowest label: a predicted county average under 2 pCi/L. USGS geology rates 100% of the county's land low radon potential.

The United States and the counties around Pike County, 2006 to 2015, laboratory
AreaTestsAt or above 4 pCi/LMedian
United States, pooled2,669 counties, pooled1,805,52836.3%Not pooled
Tangipahoa Parish, LAborders it430.0%0.1 pCi/L
Washington Parish, LAborders it10.0%0.1 pCi/L
The nearest counties to Pike County with 30 or more tests, in any state, 2006 to 2015, laboratory
CountyDistanceTestsAt or above 4 pCi/LMedian
Tangipahoa Parish, LA38 mi430.0%0.1 pCi/L
East Baton Rouge Parish, LA60 mi480.0%0.6 pCi/L
Jefferson Parish, LA97 mi671.5%0.2 pCi/L
Mobile County, AL133 mi454.4%0.2 pCi/L
Escambia County, FL184 mi510.0%0.7 pCi/L
Calcasieu Parish, LA188 mi590.0%0.2 pCi/L
Santa Rosa County, FL203 mi303.3%0.8 pCi/L
Tuscaloosa County, AL223 mi6910.1%1.1 pCi/L

Pooled shares: Radon411's sum of CDC's county counts for one period.

Pike County, Geology

The ground under Pike County

Predicted

USGS's geologic map puts all of Pike County's mapped land in one class: low radon potential. All of it lies in the area the map calls Pine Hills, to which USGS gives a radon index of 6, in the low band (5 to 8).

USGS's geologic areas under Pike County
AreaThe rock, in USGS's wordsPotentialRadon indexShare of land
Pine HillsSand, sandstone, bentonitic clay, quartzite, gravel, tuff, and siltstone.Low699.8%

Names, descriptions and indexes: U.S. Geological Survey, Geologic Radon Potential Map (2025). Shares: Radon411, from the map cut to the boundary.

Pike County beside the ground around it

Across Mississippi 0.1% of the land is rated high; none of Pike County's is. None of the 5 counties that border it has any moderate-potential ground either.

Share of land by USGS radon potential: Pike County, the 5 counties bordering it and Mississippi
AreaEPA zoneLow potentialModerate potentialHigh potential
Pike CountyZone 3100%NoneNone
Walthall CountyZone 3100%NoneNone
Lincoln CountyZone 3100%NoneNone
Amite CountyZone 3100%NoneNone
Washington Parish, LAZone 3100%NoneNone
Tangipahoa Parish, LAZone 3100%NoneNone
Mississippi82 counties, pooled by land areaVaries91.8%8.0%0.1%

The map rates the ground, not the air in any home.

What it means

Pike County, Questions

Questions about radon in Pike County

Are radon levels high in Pike County?

No CDC testing statistics are published here for Pike County, Mississippi yet. Tangipahoa Parish, LA, the one bordering county with a figure over the 2006 to 2015 laboratory totals, reported 0.0% of its tests at or above 4 pCi/L.

Which counties border Pike County?

Pike County borders 5 counties: Walthall County, MS, Lincoln County, MS, Amite County, MS, Washington Parish, LA and Tangipahoa Parish, LA.

Products

Pike County, Products

Testing a home in Pike County

No CDC figure names Pike County; the nearest county with one, Tangipahoa Parish, LA (38 miles away), reported 0.0% of its tests at or above 4 pCi/L over the 2006 to 2015 laboratory totals, the only reading nearby until a test of this home. Zone 3 is the lowest label, yet homes at or above 4 pCi/L occur in every zone: a short-term kit (2 to 90 days) is the quick first check in Pike County.

Test kits and monitors3

See every kit and monitor

Best radon monitors for Pike County homes, compared

Explore

Pike County, Bordering counties

Counties bordering Pike County

Calculated by Radon411

Pike County, Cities and towns

Cities and towns in Pike County

About 38,712 people live in Pike County by the Census Bureau's estimate for July 1, 2025, 1,482 fewer than in 2020 (−3.7%). That works out to 95 people per square mile of land. Its largest town, McComb, has 11,697 residents, 30.2% of the total. Together its 4 incorporated places hold 39.5% of those residents; the other 60.5% live outside any of them.

From McComb to Osyka, CDC publishes no figure by town: each reads Pike County's.

The cities and towns in Pike County by residents, July 1, 2025
PlaceResidentsSince 2020Share of residents
McComb11,697−5.4%30.2%
Magnolia1,804−4.1%4.7%
Summit1,417−5.2%3.7%
Osyka355−5.1%0.9%

4 incorporated places, as listed in the U.S. Census Bureau’s 2020 place reference files. Residents: U.S. Census Bureau population estimates for July 1, 2025 (Vintage 2025).

Pike County, Homes

Homes in Pike County

Of Pike County's 19,109 homes, 59% are detached houses, against 69% across Mississippi; 26% are mobile homes. Half of its homes were built before 1983, close to Mississippi's 1986: 18% date from before 1960 and 26% from 2000 or later. 67% of occupied homes are lived in by their owner (Mississippi: 69%); in the rest a tenant can run a test, but a fix is the landlord's to make.

Homes in Pike County, Mississippi, 2019 to 2023
HomesPike CountyMississippi
Housing units19,1091,332,811
Detached houses59%69%
In buildings of 5 or more6%9%
Mobile homes26%15%
Built before 196018%15%
Built since 200026%28%
Middle year built19831986
Owner-occupied67%69%

Census Bureau, American Community Survey, 2019 to 2023: estimates from a sample of homes, looser for a small place. Shares by Radon411.