Skip to content

Locations and reports

Radon Levels in Bladen County, North Carolina

EPA puts Bladen County in Zone 3, its lowest radon zone, and only 4 radon tests from it are on file with CDC (2021). Homes with elevated levels occur in all three zones, so only a test measures yours.

Data checked By Radon411Methodology

  • Highest bordering

    3.8%

    Robeson County

    Robeson
    3.8%
    Columbus
    0.0%

    3 of 5 neighbours have 30+ tests, 2008 to 2017

  • Nearest county

    0.0%

    Columbus County, 25 miles

    Columbus
    0.0%
    NC
    22.6%

    Share at 4+ pCi/L, 31 tests, 2008 to 2017

  • Ground above low

    None

    34.2 pts below NC

    Bladen
    0.0%
    NC
    34.2%

    Share of land USGS rates moderate or high potential

  • Tests reported

    14

    Too few for a share

    Bladen
    14
    Needed
    30

    2008 to 2017, laboratory

  • EPA radon zone

    Zone 3

    Lower potential

    1. 1
    2. 2
    3. Zone 3

    1 highest, 3 lowest

    EPA predicts under 2 pCi/L indoors

Read a result for Bladen County

Starts at EPA's action level

4.0pCi/L

EPA’s own thresholds; the figures are the area’s, never this home’s.

EPA’s reading of 4.0 pCi/L

At or above 4 pCi/L

  1. Under 20 to 1.9 pCi/L
  2. 2 to 4consider a fix
  3. 4 and aboveEPA says fix it

This result is at or above 4 pCi/L. EPA recommends fixing a home when the radon level is 4 pCi/L or higher.

The data

Bladen County, At a glance

Bladen County at a glance

Predicted: EPA radon zone

EPA Zone 3: lower predicted potential

is EPA's lowest class, and its forecast for Bladen County as a whole is an average indoor of less than 2 pCi/L (less than 75 Bq/m³). A low zone clears no address in it: homes above EPA's turn up in all three zones.

USGS geologic potential: Low across 100% of the county's area

Predicted: EPA Map of Radon Zones

Measured: tests reported to CDC

Radon tests reported for Bladen County, 2021

Share of reported tests at or above 4 pCi/L, by year, Bladen County
Share of reported tests at or above 4 pCi/L, by year, Bladen County
YearShare of reported tests at or above 4 pCi/L
20140.0%
20210.0%

2021: 0.0%. Across these years the share ran from 0.0% to 0.0%. Each column counts radon tests reported to CDC that year, not homes.

What these figures count

Only 4 tests were reported to CDC for Bladen County over 2021, and tests are often run on homes being sold or already suspected of a problem: so few describe neither the county nor this house.

Measured: CDC tracking data. Figure above: 2021. Measured data period: 2005 to 2021 (every CDC figure on file).

How to read these figures

Bladen County, Compared

Bladen County radon figures, compared

Calculated by Radon411

CDC's largest figure for Bladen County rests on 14 tests over the 2008 to 2017 laboratory totals, 0 of them at or above 4 pCi/L, so each test moves its share by 7.1 points and no rank or comparison is drawn from it. Results reached as high as 1.9 pCi/L, with a middle value of 0.1 pCi/L.

Of the counties bordering it, 3 have a figure over the 2008 to 2017 laboratory totals: Robeson County reported the largest share at or above 4 pCi/L, 3.8%, and Columbus County the smallest, 0.0%, with Cumberland County at 1.9% between. Farther out, Brunswick County (42 miles away) at 0.0%, New Hanover County (47 miles away) at 3.4% and Scotland County (54 miles away) at 3.2% have figures too. Pooled across 99 North Carolina counties, 22.6% of reported tests reached that level; across every county in the country with a figure, 35.7%.

Statewide for the same period, Transylvania County reported the highest share (47.8%) and Nash County the lowest (0.0%). EPA's 1993 map puts Bladen County in Zone 3, its lowest label: a predicted county average under 2 pCi/L. USGS geology rates 100% of the county's land low radon potential.

North Carolina, the United States and the counties around Bladen County, 2008 to 2017, laboratory
AreaTestsAt or above 4 pCi/LMedian
North Carolina, pooled99 counties, pooled73,13922.6%Not pooled
United States, pooled2,661 counties, pooled2,013,54435.7%Not pooled
Transylvania Countyhighest in the state3,86247.8%3.7 pCi/L
Nash Countylowest in the state300.0%0.2 pCi/L
Pender County, NCborders it1711.8%0.1 pCi/L
Robeson County, NCborders it533.8%0.8 pCi/L
Cumberland County, NCborders it1601.9%0.7 pCi/L
Sampson County, NCborders it130.0%0.6 pCi/L
Columbus County, NCborders it310.0%0.1 pCi/L
The nearest North Carolina counties to Bladen County with 30 or more tests, 2008 to 2017, laboratory
CountyDistanceTestsAt or above 4 pCi/LMedian
Columbus County25 mi310.0%0.1 pCi/L
Robeson County31 mi533.8%0.8 pCi/L
Cumberland County33 mi1601.9%0.7 pCi/L
Brunswick County42 mi620.0%0.5 pCi/L
New Hanover County47 mi1173.4%0.1 pCi/L
Scotland County54 mi313.2%1.0 pCi/L
Harnett County55 mi1810.6%0.6 pCi/L
Wayne County61 mi498.2%0.6 pCi/L
Bladen County radon tests by year, against North Carolina's pooled share
YearTestsAt or above 4 pCi/LMedianHighestNorth Carolina, pooledChange from the row before
202140.0%0.1 pCi/L0.1 pCi/L14.9%Level
201440.0%0.1 pCi/L0.7 pCi/L21.9%First on file

Pooled shares: Radon411's sum of CDC's county counts for one period.

Bladen County, Geology

The ground under Bladen County

Predicted

USGS's geologic map puts all of Bladen County's mapped land in one class: low radon potential. All of it lies in the area the map calls Inner Coastal Plain, to which USGS gives a radon index of 8, in the low band (5 to 8).

USGS's geologic areas under Bladen County
AreaThe rock, in USGS's wordsPotentialRadon indexShare of land
Inner Coastal PlainFossiliferous clay and sand, shelly sand, sandy marl, and limestone.Low8100%

Names, descriptions and indexes: U.S. Geological Survey, Geologic Radon Potential Map (2025). Shares: Radon411, from the map cut to the boundary.

Bladen County beside the ground around it

Across North Carolina 1.3% of the land is rated high; none of Bladen County's is. None of the 5 counties that border it has any moderate-potential ground either.

Share of land by USGS radon potential: Bladen County, the 5 counties bordering it and North Carolina
AreaEPA zoneLow potentialModerate potentialHigh potential
Bladen CountyZone 3100%NoneNone
Sampson CountyZone 3100%NoneNone
Columbus CountyZone 3100%NoneNone
Robeson CountyZone 3100%NoneNone
Cumberland CountyZone 3100%NoneNone
Pender CountyZone 397.0%NoneNone
North Carolina100 counties, pooled by land areaVaries64.8%33.0%1.3%

The map rates the ground, not the air in any home.

What it means

Bladen County, Questions

Questions about radon in Bladen County

Are radon levels high in Bladen County?

In 2021, 0.0% of the radon tests reported to CDC for Bladen County, North Carolina were at or above 4 pCi/L, and the median reported pre-mitigation result was 0.1 pCi/L. Of the counties bordering it, 3 have a figure over the 2008 to 2017 laboratory totals: Robeson County reported the largest share at or above 4 pCi/L, 3.8%, and Columbus County the smallest, 0.0%, with Cumberland County at 1.9% between.

Which counties border Bladen County?

Bladen County borders 5 counties: Sampson County, Columbus County, Robeson County, Cumberland County and Pender County.

Products

Bladen County, Products

Testing a home in Bladen County

No CDC figure names Bladen County; the nearest county with one, Columbus County (25 miles away), reported 0.0% of its tests at or above 4 pCi/L over the 2008 to 2017 laboratory totals, the only reading nearby until a test of this home. Zone 3 is the lowest label, yet homes at or above 4 pCi/L occur in every zone: a short-term kit (2 to 90 days) is the quick first check in Bladen County.

Test kits and monitors3

See every kit and monitor

Best radon monitors for Bladen County homes, compared

Explore

Bladen County, Bordering counties

Counties bordering Bladen County

Calculated by Radon411

Bladen County, Cities and towns

Cities and towns in Bladen County

The Census Bureau estimates 30,007 residents in Bladen County for July 1, 2025, 379 more than in 2020 (+1.3%). That works out to 34 people per square mile of land. No town dominates: Elizabethtown, the largest, has 3,306 residents, 11.0% of the total. Together its 7 incorporated places hold 24.0% of those residents; the other 76.0% live outside any of them. Reported testing is thin here: 14 tests over 2008 to 2017, or 0.5 for every 1,000 residents (2025 estimate), where North Carolina as a whole comes to 6.5.

From Elizabethtown to Tar Heel, CDC publishes no figure by town: each reads Bladen County's.

The cities and towns in Bladen County by residents, July 1, 2025
PlaceResidentsSince 2020Share of residents
Elizabethtown3,306Level11.0%
Bladenboro1,656+0.6%5.5%
White Lake850+1.3%2.8%
Clarkton604−1.5%2.0%
East Arcadia423+1.2%1.4%
Dublin267+0.8%0.9%
Tar Heel91+2.2%0.3%

7 incorporated places, as listed in the U.S. Census Bureau’s 2020 place reference files. Residents: U.S. Census Bureau population estimates for July 1, 2025 (Vintage 2025).

Bladen County, Homes

Homes in Bladen County

Of Bladen County's 15,272 homes, 62% are detached houses, against 65% across North Carolina; 32% are mobile homes. Half of its homes were built before 1983, close to North Carolina's 1990: 18% date from before 1960 and 20% from 2000 or later. 70% of occupied homes are lived in by their owner (North Carolina: 66%); in the rest a tenant can run a test, but a fix is the landlord's to make.

Homes in Bladen County, North Carolina, 2019 to 2023
HomesBladen CountyNorth Carolina
Housing units15,2724,815,195
Detached houses62%65%
In buildings of 5 or more3%14%
Mobile homes32%11%
Built before 196018%14%
Built since 200020%33%
Middle year built19831990
Owner-occupied70%66%

Census Bureau, American Community Survey, 2019 to 2023: estimates from a sample of homes, looser for a small place. Shares by Radon411.