Skip to content

Locations and reports

Radon Levels in Collingsworth County, Texas

EPA puts Collingsworth County in Zone 3, its lowest radon zone, and only 1 radon test from it is on file with CDC (2008 to 2017, laboratory totals). Homes with elevated levels occur in all three zones, so only a test measures yours.

Data checked By Radon411Methodology

  • Nearest county

    71.4%

    Randall County, 92 miles

    Randall
    71.4%
    Texas
    10.4%

    Share at 4+ pCi/L, 84 tests, 2007 to 2016

  • Ground above low

    1.3%

    26.0 pts below Texas

    Collingsworth
    1.3%
    Texas
    27.3%

    Share of land USGS rates moderate or high potential

  • Tests reported

    1

    Too few for a share

    Collingsworth
    1
    Needed
    30

    2008 to 2017, laboratory

  • EPA radon zone

    Zone 3

    Lower potential

    1. 1
    2. 2
    3. Zone 3

    1 highest, 3 lowest

    EPA predicts under 2 pCi/L indoors

Read a result for Collingsworth County

Starts at EPA's action level

4.0pCi/L

EPA’s own thresholds; the figures are the area’s, never this home’s.

EPA’s reading of 4.0 pCi/L

At or above 4 pCi/L

  1. Under 20 to 1.9 pCi/L
  2. 2 to 4consider a fix
  3. 4 and aboveEPA says fix it

This result is at or above 4 pCi/L. EPA recommends fixing a home when the radon level is 4 pCi/L or higher.

The data

Collingsworth County, At a glance

Collingsworth County at a glance

Predicted: EPA radon zone

EPA Zone 3: lower predicted potential

is EPA's lowest class, and its forecast for Collingsworth County as a whole is an average indoor of less than 2 pCi/L (less than 75 Bq/m³). A low zone clears no address in it: homes above EPA's turn up in all three zones.

USGS geologic potential: Low across 99% of the county's area

Predicted: EPA Map of Radon Zones

Measured: tests reported to CDC

Radon tests reported for Collingsworth County, 2008 to 2017, laboratory

CDC holds 1 reported test for Collingsworth County over the 2008 to 2017 laboratory totals, a result of 12.6 pCi/L: too few to describe a county (Radon411 reads a share from 30 tests up). Collingsworth County beside the counties around it is how this page reads it.

What these figures count

Only 1 test was reported to CDC for Collingsworth County over 2008 to 2017 (laboratory totals), and tests are often run on homes being sold or already suspected of a problem: so few describe neither the county nor this house.

Measured: CDC tracking data. Figure above: 2008 to 2017, laboratory. Measured data period: 2005 to 2017 (every CDC figure on file).

How to read these figures

Collingsworth County, Compared

Collingsworth County radon figures, compared

Calculated by Radon411

CDC's largest figure for Collingsworth County rests on 1 test over the 2008 to 2017 laboratory totals, 1 of them at or above 4 pCi/L, so each test moves its share by 100.0 points and no rank or comparison is drawn from it. Results reached as high as 12.6 pCi/L, with a middle value of 12.6 pCi/L.

The nearest counties with a figure are Randall County (92 miles away) at 71.4%, Potter County (97 miles away) at 20.0% and Lubbock County (129 miles away) at 57.8%. Pooled across 140 Texas counties, 10.4% of reported tests reached that level; across every county in the country with a figure, 35.8%.

Statewide for the same period, Randall County reported the highest share (71.4%) and Nueces County the lowest (0.0%). EPA's 1993 map puts Collingsworth County in Zone 3, its lowest label: a predicted county average under 2 pCi/L. USGS geology rates 99% of the county's land low radon potential.

Texas, the United States and the counties around Collingsworth County, 2007 to 2016, laboratory
AreaTestsAt or above 4 pCi/LMedian
Texas, pooled140 counties, pooled4,54810.4%Not pooled
United States, pooled2,666 counties, pooled1,939,02535.8%Not pooled
Randall Countyhighest in the state8471.4%6.2 pCi/L
Nueces Countylowest in the state450.0%0.6 pCi/L
Donley County, TXborders it1100.0%4.0 pCi/L
Childress County, TXborders it10.0%1.1 pCi/L
Beckham County, OKborders it30.0%1.8 pCi/L
Gray County, TXborders it30.0%1.9 pCi/L
Wheeler County, TXborders it30.0%2.7 pCi/L
The nearest Texas counties to Collingsworth County with 30 or more tests, 2007 to 2016, laboratory
CountyDistanceTestsAt or above 4 pCi/LMedian
Randall County92 mi8471.4%6.2 pCi/L
Potter County97 mi7020.0%1.1 pCi/L
Lubbock County129 mi12857.8%4.8 pCi/L
Denton County218 mi1817.2%0.9 pCi/L
Tarrant County228 mi31210.6%0.9 pCi/L
Midland County236 mi1001.0%0.7 pCi/L
Collin County245 mi2847.7%1.0 pCi/L
Dallas County251 mi6998.7%1.0 pCi/L
Collingsworth County ten-year laboratory totals, against Texas' pooled share
PeriodTestsAt or above 4 pCi/LMedianHighestTexas, pooledChange from the row before
2008 to 20171100.0%12.6 pCi/L12.6 pCi/L10.2%Level
2007 to 20161100.0%12.6 pCi/L12.6 pCi/L10.4%Level
2006 to 20151100.0%12.6 pCi/L12.6 pCi/L11.0%Level
2005 to 20141100.0%12.6 pCi/L12.6 pCi/L10.6%First on file

Pooled shares: Radon411's sum of CDC's county counts for one period.

Collingsworth County, Geology

The ground under Collingsworth County

Predicted

Most of the ground under Collingsworth County is one class on USGS's geologic map: 98.7% of its land is low radon potential, with 1.3% moderate. 98.6% of it lies in the area the map calls Central Texas, to which USGS gives a radon index of 7, in the low band (5 to 8).

USGS's geologic areas under Collingsworth County
AreaThe rock, in USGS's wordsPotentialRadon indexShare of land
Central TexasCretaceous through Quaternary marine sandstone, shale, chalk, limestone, siltstone, clay, and lignite.Low798.6%
Northern High Plains and PlateausTertiary sandstone, siltstone, shale.Moderate101.3%

Names, descriptions and indexes: U.S. Geological Survey, Geologic Radon Potential Map (2025). Shares: Radon411, from the map cut to the boundary.

Collingsworth County beside the ground around it

Across Texas 0.5% of the land is rated high; none of Collingsworth County's is. Of the 7 counties that border it, 3 have more moderate-potential ground, Gray County the most at 93.0%.

Share of land by USGS radon potential: Collingsworth County, the 7 counties bordering it and Texas
AreaEPA zoneLow potentialModerate potentialHigh potential
Collingsworth CountyZone 398.7%1.3%None
Harmon County, OKZone 3100%NoneNone
Wheeler CountyZone 352.6%47.4%None
Donley CountyZone 241.3%58.7%None
Childress CountyZone 3100%NoneNone
Hall CountyZone 3100%NoneNone
Beckham County, OKZone 399.9%0.1%None
Gray CountyZone 27.0%93.0%None
Texas254 counties, pooled by land areaVaries72.4%26.8%0.5%

The map rates the ground, not the air in any home.

Local help

Collingsworth County, Local resources

Radon testing and mitigation in Collingsworth County

What it means

Collingsworth County, Questions

Questions about radon in Collingsworth County

Are radon levels high in Collingsworth County?

Over the 2008 to 2017 laboratory totals, 100.0% of the radon tests reported to CDC for Collingsworth County, Texas were at or above 4 pCi/L, and the median reported pre-mitigation result was 12.6 pCi/L. Of the 8 nearest counties with a figure, within 251 miles, the share of tests at or above 4 pCi/L runs from 1.0% to 71.4%.

Which counties border Collingsworth County?

Collingsworth County borders 7 counties: Harmon County, OK, Wheeler County, TX, Donley County, TX, Childress County, TX, Hall County, TX, Beckham County, OK and Gray County, TX.

Products

Collingsworth County, Products

Testing a home in Collingsworth County

No CDC figure names Collingsworth County; the nearest county with one, Randall County (92 miles away), reported 71.4% of its tests at or above 4 pCi/L over the 2007 to 2016 laboratory totals, the only reading nearby until a test of this home. Zone 3 is the lowest label, yet homes at or above 4 pCi/L occur in every zone: a short-term kit (2 to 90 days) is the quick first check in Collingsworth County.

Test kits and monitors3

See every kit and monitor

Best radon monitors for Collingsworth County homes, compared

Explore

Collingsworth County, Bordering counties

Counties bordering Collingsworth County

Calculated by Radon411

Collingsworth County, Cities and towns

Cities and towns in Collingsworth County

Collingsworth County has been losing residents: from 2,642 in 2020 to 2,487 on July 1, 2025, a fall of 5.9% by the Census Bureau's estimates. Spread over its land, that is 2.7 people to the square mile. Wellington alone is home to 1,770 of them, 71.2% of the total. Together its 2 incorporated places hold 74.7% of those residents; the other 25.3% live outside any of them. Testing is reported here more often than across the state: CDC's 1 reported test for 2008 to 2017 come to 0.4 for every 1,000 residents (2025 estimate), against 0.1 for Texas.

From Wellington to Dodson, CDC publishes no figure by town: each reads Collingsworth County's.

The cities and towns in Collingsworth County by residents, July 1, 2025
PlaceResidentsSince 2020Share of residents
Wellington1,770−6.2%71.2%
Dodson89−5.3%3.6%

2 incorporated places, as listed in the U.S. Census Bureau’s 2020 place reference files. Residents: U.S. Census Bureau population estimates for July 1, 2025 (Vintage 2025).

Collingsworth County, Homes

Homes in Collingsworth County

Collingsworth County is a place of houses on their own lots: 83% of its 1,471 homes are detached single-family houses, against 65% across Texas. The homes are older than Texas' as a whole: half were built before 1961 (1990 for Texas), and 48% date from before 1960. 75% of occupied homes are lived in by their owner (Texas: 63%); in the rest a tenant can run a test, but a fix is the landlord's to make.

Homes in Collingsworth County, Texas, 2019 to 2023
HomesCollingsworth CountyTexas
Housing units1,47111,890,808
Detached houses83%65%
In buildings of 5 or more1%21%
Mobile homes4%7%
Built before 196048%13%
Built since 20009%37%
Middle year built19611990
Owner-occupied75%63%

Census Bureau, American Community Survey, 2019 to 2023: estimates from a sample of homes, looser for a small place. Shares by Radon411.